TP-Link TW-MR3220 User Manual page 20

5. Configure the Wireless settings on the screen as shown below, then click Next.
Wireless Radio - Enable or disable the wireless radio choosing from the pull-down list.

Wireless Network Name - Enter a value of up to 32 characters. The same name of

Wireless Network Name (SSID) must be assigned to all wireless devices in your network.
Considering your wireless network security, the default Wireless Network Name is set to
be TP-LINK_XXXXXX (XXXXXX indicates the last six unique numbers of each Router's
MAC address). This value is case-sensitive. For example, TEST is NOT the same as test.
Region - Select your region from the pull-down list. This field specifies the region where

the wireless function of the Router can be used. It may be illegal to use the wireless
function of the Router in a region other than one of those specified in this field. If your
country or region is not listed, please contact your local government agency for
assistance.
Channel - This field determines which operating frequency will be used. The default

channel is set to Auto, so the AP will choose the best channel automatically. It is not
necessary to change the wireless channel unless you notice interference problems with
another nearby access point.
Mode - This field determines the wireless mode which the Router works on.

Channel Width - Select any channel width from the pull-down list. The default setting is

automatic, which can adjust the channel width for your clients automatically.
Wireless Security - You can select one of the following security options.

Disable Security - The wireless security function can be enabled or disabled. If

disabled, the wireless stations will be able to connect the Router without encryption. It
is recommended strongly that you choose one of following options to enable security.
WPA-Personal/WPA2-Personal - Select WPA based on pre-shared passphrase.

Password - You can enter ASCII or Hexadecimal characters.
TL-MR3220 3G/4G Wireless N Router User Guide
-9-