Table of Contents
Advertisement
Configuring the HP Processor Probe for PowerPC 603/603e
To configure the HP processor probe
Use one of the following ways to configure the HP processor probe:
•
Start a user interface without specifying a configuration file.
In this case the configuration of HP processor probe is not changed from the
last configuration settings. If the user interface does not provide a way to
issue terminal mode commands directly to the probe, you can telnet to the
probe and set the configuration manually before starting the user interface.
When power is cycled on the HP processor probe, the configuration is
restored to the default values listed above.
•
Start a user interface, loading a configuration file (for interfaces that
allow loading a configuration file).
In this case, the HP processor probe is initialized with the values in the
configuration file. The configuration file should be a list of "cf" commands to
be sent to the probe.
•
Modify the configuration from within the user interface.
When a user interface is started, individual "cf" commands can be sent to the
probe either through the user interface or by using telnet to connect to the
probe. A telnet session and user interface can be connected to the probe at
the same time.
38
Advertisement
Table of Contents
