Troubleshooting,26 - Hotpoint Ariston PH 940MS HA Operating Instructions Manual

Cleaning the appliance
GB
! Do not use abrasive or corrosive detergents such as stain removers, anti-rust
products, powder detergents or sponges with abrasive surfaces: these may
scratch the surface beyond repair.
! Never use steam cleaners or pressure cleaners on the appliance.
• It is usually enough to wash the hob with a damp sponge and dry it with
absorbent kitchen roll.
• The removable parts of the burners should be washed frequently with
warm water and soap and any burnt-on substances removed.
• For hobs which ligth automatically, the terminal part of the electronic instant
lighting devices should be cleaned frequently and the gas outlet holes
should be checked for blockages.
• The electric hotplates should be cleaned with a damp cloth and lubricated
with a little oil while still warm.
• Stainless steel can be marked by hard water that has been left on the
surface for a long time, or by aggressive detergents containing phosphorus.
After cleaning, rinse and dry any remaining drops of water.
Special cleaning products for ceramic glass
surfaces form a transparent protective
layer which fights diry buildup. This also
protects the surface from damage caused
by food with a high sugar content. Do not
use abrasive sponges or cleaning products
under any circumstances. This holds true
for chemically aggressive cleaners, like
oven sprays and stain removers.
• When cleaning the grill, it is recommeded
that you do so while it is still hot, using the
handles provided to move it from the cooktop
to the sink. To remove the pan beneath
the grill, it is a good idea to wait until the
heating element has cooled (roughly after
15 minutes).
element in between.
Gas tap maintenance
Over time, the taps may become jammed or difficult to turn. If this happens,
the tap must be replaced.
! This procedure must be performed by a qualified technician authorised
by the manufacturer.
26
T h e
packaging includes the cast-iron steak
grill and the stainless-steel grease-
collection tray together with grids and
burners.
Place the tray under the heating
element (see Figure) and the streak
grill over it so as to enclose the heating
Troubleshooting
It may happen that the appliance does not function properly or at all. Before
calling the service centre for assistance, check if anything can be done. First,
check to see that there are no interruptions in the gas and electrical supplies,
and, in particular, that the gas valves for the mains are open.
The burner does not light or the flame is not even around the burner.
Check whether:
• The gas holes on the burner are clogged.
• All the movable parts that make up the burner are mounted correctly.
• There are draughts near the appliance.
The flame dies in models with a safety device.
Check to make sure that:
• You pressed the knob all the way in.
• You keep the knob pressed in long enough to activate the safety device.
• The gas holes are not blocked in the area corresponding to the safety
device.
The burner does not remain lit when set to minimum.
Check to make sure that:
• The gas holes are not blocked.
• There are no draughts near the appliance.
• The minimum setting has been adjusted properly.
The cookware is unstable.
Check to make sure that:
• The bottom of the cookware is perfectly flat.
• The cookware is positioned correctly at the centre of the burner.
• The pan support grids have been positioned correctly.