Troubleshooting - KitchenAid KSBC1B0CU Manual

CARE AND CLEANING
SANITIZING THE BLENDER
1. Remove any remaining contents from the Blender Jar.
2. Prepare a 200 ppm sodium hypochlorite solution* using 1.75 L of hot water in the
Blender Jar. Place the Lid on the Blender Jar, and make sure the Blender Jar is fully in
place on the Blender Base.
3. Run the Blender on the High Speed setting for 35 seconds. Flip the START/STOP
toggle switch up or down to start the Blender.
4. Turn off the Blender and let the sanitizing mix sit in the Blender Jar for an
additional 2 minutes.
5. Pour out the sanitizing solution mix. Do not rinse the Blender Jar.
6. Place the Lid on the Blender Jar. Make sure the empty Blender Jar is fully in place on
the blender base. Run the empty Blender for an additional 10 seconds. Do not rinse
the jar after sanitizing.
7. Allow the Blender Jar to air dry.
*To prepare a 200 ppm sodium hypochlorite solution: use 6.67 ml household bleach (with a 5.25% sodium
hypochlorite concentration) in 1.75 L of hot water.

TROUBLESHOOTING

Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
PROBLEM
When the Blender is plugged in and
the main power On/Off (I/O) toggle
switch is on (I), the Blender will go
to Standby mode (flashing white
indicator light). However, after 10
minutes of no activity the Blender
will go into Sleep mode and the
indicator light will turn off:
If the Status Indicator Light flashes
an orange color, the Blender is in
error mode. This can be caused by:
using a spatula or any other utensil
that could obstruct the blade to
freely spin in the Blender Jar, or
having an ice cube or hard food in a
location that locks up the blade:
10
W11593908B.indb 10 W11593908B.indb 10
WARNING
Electrical Shock Hazard
SOLUTION
To wake up the Blender simply flip the
START/STOP toggle switch up or down. This will
put the Blender back into Standby mode.
Correct the problem by turning off the Blender
using the dedicated On/Off Toggle Switch in the
back, or by unplugging the Blender.
Remove the Blender Jar from the base, and clear
the items. Place the Blender back on the base,
and then turn the Blender back on to continue
regular use.
9/19/2022 9:47:21 AM 9/19/2022 9:47:21 AM