Stihl HSA 60.0 Instruction Manual page 30

English
4.7 Operation
WARNING
■ The user cannot concentrate on the work in
certain situations. The user may stumble, fall
and be seriously injured.
► Work calmly and carefully.
► If light and visibility are poor: Do not use
your hedge trimmer.
► Operate the hedge trimmer alone.
► Watch out for obstacles.
► Stand on the ground while working and
keep a good balance. If it is necessary to
work at heights: Use a lift bucket or a safe
platform.
► If you begin to feel tired: Take a break.
■ Working above shoulder height can cause you
to tire quickly. This can result in serious inju‐
ries.
► Work above shoulder height for short peri‐
ods only.
► Take regular breaks.
■ If the moving cutting blades make contact with
a hard object they can be brought to a sudden
stop. The reactive forces that occur can cause
the user to lose control of the hedge trimmer
and be seriously injured.
► Hold the hedge trimmer firmly with both
hands.
► Before starting work, check hedge for hard
objects and remove any such objects.
■ The moving cutting blades can cut the user.
This can result in serious injuries.
► Do not touch moving cutting blades.
► If the cutting blades are blocked by
an object: Switch off the hedge trim‐
mer and remove the battery. Then
remove the object causing the block‐
age.
■ If the behavior of the hedge trimmer changes
during operation or feels unusual, it may no
longer be in a safe condition. This can result in
serious injuries and damage to property.
► Stop work, remove the battery and contact
your STIHL servicing dealer for assistance.
■ Hedge trimmer vibrations may occur during
operation.
► Wear gloves.
► Take regular breaks.
► If signs of circulation problems occur: Seek
medical advice.
■ Note that the cutting blades continue to run for
about 1 second after you release the trigger.
The moving cutting blades can cut the user.
This can result in serious injuries.
30
► Hold the hedge trimmer firmly by the control
handle and loop handle and wait until the
cutting blades come to a complete stand‐
still.
DANGER
■ Working near live electric cables can result in
accidental contact with the cutting blades and
damage the cables. This can result in serious
or fatal injuries.
► Do not work near live electric cables.
4.8 Charging
WARNING
■ A damaged or defective charger may produce
an unusual smell or emit smoke during the
charging process. This may result in personal
injuries and damage to property.
► Disconnect the plug from the wall outlet.
■ The charger can overheat and cause a fire if
heat dissipation is inadequate. This can result
in serious or fatal injuries and damage to prop‐
erty.
► Do not cover the charger.
4.9 Connecting to the power supply
Contact with live components may occur for the
following reasons:
– The connecting cable or the extension cord is
damaged.
– The mains plug of the connecting cable or
extension cord is damaged.
– The socket is not properly installed.
DANGER
■ Contact with live parts may result in electric
shock. This may result in serious or fatal injury
to the user.
► Make sure that the connecting cable, exten‐
sion cord and their mains plugs are undam‐
aged.
If the connecting cable or the extension
cord is damaged:
► Do not touch the damaged area.
► Disconnect the mains plug from the
power supply.
► Make sure your hands are dry before touch‐
ing the connecting cable, extension cord or
mains plugs.
► Plug the mains plug of the connecting cable
or extension cord into a properly installed,
shockproof socket with the correct fuse rat‐
ing.
► Install the charger with a ground fault circuit
interrupter (30 mA, 30 ms).
4 Safety Precautions
0458-019-9801-A