Table of Contents
Advertisement
10
Operation
10.1
Switching on the device
Plug the power adaptor into its socket on the rear panel, now connect the power cord to AC power
output. Now switch ON the mains and switch ON the stirrer from the front side, as shown in the
figure. The power LED on its front panel will glow.
Important note: Values of any parameter will get set saved only after the respective display
blinks for 5 times.
10.2
Setting Time
The time in the display will show in minutes. The stirrer timer set for operation is in between 1min
to 999 mins and infinite. Infinite time is seen as ")(". To set time, press "TIME" button and then set
the value by pressing "+/‐" button. When time button is pressed, the "Mins" display will blink
indicating the time value is selected. Once time value is selected, single press "+/‐" will increase
or decrease time value by 1min.
Long press increment or decrement button to quickly increase or decrease time value. Time value
gets saved after multiple blinks. The timer is a countdown timer showing remaining time left. Once
time is over, the stirrer stops.
10.3
Setting Speed
Speed is displayed as RPM. The minimum and maximum speed of stirrer is 200 RPM and 2200
RPM respectively. When the equipment is used for the 1st time, the speed will be set to zero and
shown as "0". Once speed value is selected, single press "+/‐" will increase or decrease speed
value by 10 RPM. Long press"+/‐" to quickly increase or decrease speed value. Speed value get
saved after 5 blinks.
© PCE Instruments
8
Advertisement
Table of Contents
