Vivreau V3-201 Troubleshooting Manual
Hide thumbs Also See for V3-201:

Advertisement

Quick Links

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the V3-201 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Vivreau V3-201

  • Page 1 V3-201, V3-202, V3-204, V3-205 Troubleshooting Guide Contents Still water is slower than normal and/or carbonator is running very loud. No still water. No sparkling water. Water leak. Service light is on. Water is dispensing warm. Sparkling water is flat. CO2 light is on.
  • Page 2 Likely needs a filter change Still water is slower Check that main than normal and/or water supply is carbonator is running fully open very loud Turn valve completely on and check for proper operation Still side is frozen. With power on open both Thawing once should solve the taps and continue to run sparkling water until issue.
  • Page 3 Customer must resolve open? power issue. Confirm CO2 is turned on Outlet and full. Confirm pressure readings on CO2 and working contact our Service Team Confirm that the leak is coming Water leak from the vivreau system and contact our Service Team...
  • Page 4 Likely needs a filter change contact our Service Team Is still water slower than normal? Does still water Now reset the carbonator Service light is on dispense from the to get the sparkling water to still tap? work again and service light Make sure the water to turn off.
  • Page 5 Clean the condenser grill with a soft brush or cloth and remove any obstructions to the airflow. Is the condenser grill clogged or obstructed? Is the machine plugged into a working outlet and Water is dispensing Make sure the water supply the power switch is in the warm Once machine is powered...
  • Page 6 Replace CO2 tank Turn CO2 tank on CO2 light is on Is the CO2 tank empty? Is CO2 tank off at the tank or secondary shutoff valve? contact our Service Team Drip tray light is on Empty internal or external drip tray container Machine makes noise after or during...
  • Page 7 Hook up a new tank Contact our Did the new tank and monitor tank Service Team hold pressure? CO2 level over the Is the gasket next 24- 48 hours between the CO2 Leak regulator and tank in place? Get a replacement washer from CO2 provider and install ASAP...

This manual is also suitable for:

V3-202V3-204V3-205

Table of Contents