Top Holder - DAAN Groups VoltzToys SX1719 User Manual

5. TOP HOLDER ASSEMBLY
Parts Required: Top Holder A, B, C, Hex Bolt, Nut Bolt, 20MM Screws*4
Holder A Holder B Holder C
Position Top Holder A and Top Holder B together to align their screw holes. To-
gether with Top Holder A and B, insert both parts into Top Holder C. When all
parts are aligned, fix with a bolt and nut. The bolt and nut should pass through
Top Holder A, B, and C.
The overhead light assembly includes an LED wire, which can be inserted through
Top Holder B and C. One side will have designated cut-outs for the wire to pass
through. Connect the LED wire by locating it's pair connector from the car body.
With the entire assembled Top Holder Assembly, insert into the car body, and fix
with screws underneath the car. (Attention: Please make sure you install the nut
and bolt on the correct hole. The holes can be identified on their opening, either
a circle or hexagon. The bolt must be inserted through the circle opening, and the
nut is fixed from the hexagon opening.
9