Page 1
WE-EF LEUCHTEN Installation and Maintenance Instructions Inground Luminaire ETC310-FS LED EVC310-FS LED ETC319-FS LED EVC319-FS LED Do not open during installation Surge Protection This product is factory-sealed. This product features built-in surge protection circuitry in compliance with Refer to the instructions contained in this applicable standards.
Light Source Maintenance Apart from cleaning the product’s exterior surfaces, no special maintenance work is required. Do not use high-pressure cleaners. In case of component failure due to abnormal circumstances or at end of life, replacement must be carried out Warning: Do not open luminaire while mains supply is switched on.
Installation Installation Methods The product must be installed and maintained by a Attention: The luminaire is factory-sealed and does not need to be opened during installation. building/construction and/or electrical regulations and relevant legislation. For proper installation, use the supplied installation blockout.
Page 5
Phase One Phase Two Blockout Installation Procedure Luminaire Installation and Electrical Connection (during earth or masonry work) 1) Ensure that proper drainage is provided for the 8) Check that rating shown on luminaire label conforms shown installation methods. with mains electrical supply. 2) Ensure a suitable recess is provided to accommo- E from luminaire housing A and date installation blockout/mounting ring assembly...