Table of Contents
Advertisement
With the Full-duplex firmware
In full-duplex mode, you will have to configure a mono input and a mono output.
To do so, go to the audio page 'Audio: Stream priority 2':
Configure the IP stream to be received (Listening stream) and the IP stream to be sent (Server stream).
PYKO-in is now configured for a full-duplex communication.
In Audio Manager mode, the Audio Manager stream will automatically be set to level 2.
It is also possible to define a priority stream via the page 'Audio: Stream priority 1'.
A full-duplex communication can then be interrupted by this priority stream for, e.g., an alarm message.
12
Advertisement
Table of Contents
Need help?
Do you have a question about the PYKO-in and is the answer not in the manual?
Questions and answers