Supermicro SuperServer 1029P-MT User Manual page 51

VGA Enable/Disable
JPG1 allows you to enable or disable the VGA port using the onboard graphics controller.
The default setting is Enabled.
Manufacturing Mode
Close JPME2 to bypass SPI flash security and force the system to use the Manufacturing
Mode, which will allow you to flash the system firmware from a host server to modify system
settings. See the table below for jumper settings.
I C Bus for VRM
2
Jumpers JVRM1 and JVRM2 allow the BMC or the PCH to access CPU and memory VRM
controllers. See the table below for jumper settings.
VGA Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
Manufacturing Mode Select
Jumper Settings
Jumper Setting Definition
Pins 1-2 Normal (Default)
Pins 2-3 Manufacturing Mode
VRM
Jumper Settings
Jumper Setting Definition
Pins 1-2 BMC (Normal)
Pins 2-3 PCH
51
Chapter 4: Motherboard Connections