Table of Contents
Advertisement
P
F
Lacement anD
Raming
1"
25mm
Clearance from
framing studs
to venting
Figure 33: U37 Minimum Framing
is a 3/8 NPT fitting to connect the gas line to. The electrical wiring must also be brought to the right side.
The location of the appliance should be chosen so there will be at least a 36 inches (914 mm) clearance
from drapes, doors and other combustible materials.
Combustible material may be brought up to any finishing edge
(CSS) has been correctly activated allowing heat in the chase to be vented. This system keeps the
front wall cool enough for any combustible materials. The supplied non-combustible board can still be used
but is not mandatory when the CSS is activated, com-
bustible material may overlap in this situation.
If the CSS has NOT been activated (Tradition-
MUST
al Install) you
material directly above the appliance extend-
ing up the front wall 12" from the top finish-
ing edge, it is recommended to use the supplied
non-combustible board. Combustible material must
NOT be brought up to the top finishing edge. Also
combustible material CANNOT overlap the non-com-
bustible board on a traditional installation.
NOTE: These are exact dimensions, add
tolerance when cutting finishing material to
ensure fit around the finishing edge.
Initial Installation
QUALIFIED INSTALLERS ONLY
:
44 / "
1283 mm
79 ½"
2172 mm
Refer to Table 1
Refer to Table on left
use a non-combustible
(2" facing mat.)
Maximum Depth
(½" facing mat.)
46 / "
The location for the appliance
1359 mm
can be raised, at floor level, or
installed in a corner. There are
minimum framing measurements
for each situation. The basic
rough
the following dimensions (see
Figure 33). The appliance must
be placed on a strong and level
surface.
The gas line must be run to the
right side of the appliance, there
ONLY
32 / "
Figure 34: Finishing Edge Dims
Table 1: U37 Framing Depth
Minimum Depth
22 3/4"
24 1/4"
NOTE: When framing the unit, care
must be taken to consider the final
floor thickness, the bottom of the
appliance must sit flush with the
finished floor to ensure proper fit of
the surround components.
opening
should
if the Cool Surface System
37 / "
578 mm
616 mm
have
23
Advertisement
Table of Contents
