Table of Contents
Advertisement
Do not start the Pyrolysis if
you did not fully close the
oven door. In some models,
the display shows "C3"
when this error occurs.
WARNING!
The appliance becomes very
hot. There is a risk of burns.
CAUTION!
Do not use the hob at the
same time as the Pyrolysis
function. It can cause
damage to the appliance.
1. Remove the worst dirt manually.
2. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
3. Set the Pyrolysis function. Refer to
"Oven functions".
4. When
flashes, press
set the necessary procedure:
Option
P1
P2
Press
or turn the knob for the
temperature to start the procedure.
You can use the End function to delay
the start of the cleaning procedure.
During the Pyrolysis the oven lamp is off.
5. To change the default length of the
procedure (P1 or P2), press
, and then press
the length of the cleaning procedure.
6. When the oven is at its set
temperature, the door locks. The
display shows the symbol
7. When Pyrolysis is completed, the
8. When the appliance is cool again, an
11.4 Cleaning reminder
To remind you that the Pyrolysis is
necessary, PYR flashes in the display for
10 seconds after each activation and
deactivation of the appliance.
or
to
11.5 Removing the shelf
supports
Description
To clean the oven, remove the shelf
If the oven is
supports.
not very dirty.
1. Pull the front of the shelf support
Time of the
procedure: 1
h 30 min.
If you cannot
easily remove
the dirt. Time
of the proce-
dure: 2 h 30
min.
2. Pull the rear end of the shelf support
to set
or
to set
and the
bars of the heat indicator until the
door unlocks.
display shows the time of day. The
oven door stays locked.
acoustic signal sounds and the door
unlocks.
The cleaning reminder
goes out:
• after the end of the
Pyrolysis function.
• if you press
the same time while PYR
flashes in the display.
away from the side wall.
away from the side wall and remove
it.
ENGLISH
29
and
at
Advertisement
Table of Contents
