Advertisement
Installation
1
Installing the mounting bracket
□
Unscrew the two cap nuts (HH) and rubber washer(GG) from the
mounting screws (BB). Remove the mounting bracket (AA)from
the fixture body (A), and keep the cap nuts (HH) and rubber
washer (GG) for later use. Loosen the hex nuts (EE) on the
mounting screws (BB) and adjust the mounting screws (BB) so
that they extend long enough to protrude the canopy of the
fixture body (A), then secure the mounting screws (BB) in place
using the hex nuts (EE).
AA
BB
EE
2
Connecting the wires
Connect the white wire from the light fixture to the white
□
supply wire from the junction box using a connector (FF).
Connect the black wire from the light fixture to the black
supply wire from the junction box using a connector (FF).
Connect the ground wire from the light fixture to the ground
supply wire from the junction box using a connector (FF). Push
the wires into the junction box. Mount the fixture body (A) onto
the mounting bracket (AA) and secure with the mounting
screws (BB).
FF
White
Black
Ground wire
AA
GG
A
A
BB
WARNING: Turn off power at the circuit breaker and the
light switch. Ensure the power is off before continuing.
Fasten the mounting bracket (AA) onto the outlet box using
□
two outlet box screws (CC).The side of the mounting bracket
(AA) marked "GND" must face out.
HH
3
Installing the light fixture
Place the fixture body (A) over the outlet box, and ensure the
□
heads of the mounting screws (BB) come through the holes of
the fixture body (A). Place the rubber washers (GG) over the
mounting screws (BB), and tighten the cap nuts (HH) onto the
mounting screws (BB) until the fixture body (A) is held firmly
against the wall. Use weather resistant caulk (not included) to
seal around the top and side perimeter of the back plate of the
fixture body (A). Do not caulk the bottom of the back plate to
allow for condensation evaporation.
BB
5
Please contact 1-855-HD-HAMPTON for further assistance.
AA
GG
HH
A
Install the light bulb (not
included) in the socket of
fixture body (A). Use one
maximum 4W Type A medium
base LED bulb or one
maximum 60W Type A medium
base regular filament Edison
bulb .
WWW.HAMPTONBAY.COM
CC
Advertisement
