Gree Crossover GWH09AGC-D3DNA2B/I Operation Manual page 16

Once completed, press the TURBO button (
3. Following confirmation, the time displayed on the remote control screen will automatically
increase by 1 hour (going from "
temperature display will blink, as previously.
4. Repeat the above steps 2 and 3 until the temperature is set for all 8 hours of the sleep curve.
Once the sleep curve setting is completed, the time and temperature display on the remote con-
trol will return to its original display.
The user can view or revise a custom sleep curve. Hold down the TURBO button (
some time until the remote control enters user customization status. To view the setting without
change, simply press the TURBO button (
to be adjusted, Use the arrow buttons(▲ or ▼) to do so then pressa the TURBO button (
confirm the new setting.
NOTES :
▪ While setting a custom sleep curve, if no operation is performed for more than 10 seconds, the process
will be automatically cancelled and the time and temperature display on the remote control will return
to its original display.
▪ While setting a custom sleep curve, pressing the POWER (
automatically cancel the process.
WIFI FUNCTION
Allows the user to control the unit remotely from their smartphone or tablet using the GREE+ App.
Press the WIFI button (
the display screen of the remote control. Holding down the WIFI button (
deactivate the WiFi function.
Holding down the MODE (
module to factory settings.
NOTE : This function is only available for some models.
HEATLH AND SCAVENGING MODES
Allows the unit to clean the air by removing dust particles and germs and/or to gradually replace stale air
inside the room with fresh outside air.
Press the HEALTH / SCAVENGING button (
With each press of the button, the setting options cycle through in the following order :
16
OPERATION GUIDE
" to "
) on the remote control to activate the function. The word " WiFi " will appear on
) and WIFI ( ) buttons simultaneously for 1 second will restore the WiFi
Scavenging Scavenging
mode only & Heath modes
) to confirm the setting.
", then " ", and so on up to "
) to move on to the next setting. If a setting needs
), MODE (
) on the remote control to select the desired mode(s).
Health
mode only
OFF
(no display)
") and the
) or SLEEP ( ) button will
) for at least 5 seconds will
) for
) to