Gree Crossover GWH09AGC-D3DNA2B/I Operation Manual page 14

Holding the button down continuously for more than 2 seconds will cause the airflow deflectors and louvers
to automatically swing back and forth, and sides to sides. When the button is released, the unit stops swing-
ing at the current angle, providing the user with a personalized fixed angle.
NOTE : Some angle options are only available for certain models.
TIMER SETTING
SWITCH-ON TIMER
Allows the user to set a switch-on timer. The unit will switch on once the start delay has been reached.
Press the TIMER-ON button (
mote control will disappear and the word " ON " will start blinkling. Use the arrow buttons (▲ or ▼) to set the
desired time. Each press of either button increases or decreases the time by 1 minute. Holding either button
down for more than 2 seconds will cause the minutes to scroll up or down more quickly. Once completed,
press the TIMER-ON button (
screen and the word " ON " will stop blinking.
To cancel a switch-on timer that has been set, press the TIMER-ON button (
SWITCH-OFF TIMER
Allows the user to set a switch-off timer. The unit will stop running when the set operating time has elapsed.
Press the TIMER-OFF button (
mote control will disappear and the word " OFF " will start blinkling. Use the arrow buttons (▲ or ▼) to set the
desired time. Each press of either button increases or decreases the time by 1 minute. Holding either button
down for more than 2 seconds will cause the minutes to scroll up or down more quickly. Once completed,
press the TIMER-OFF button (
screen and the word " OFF " will stop blinking.
To cancel a switch-off timer that has been set, press the TIMER-OFF button (
NOTES :
▪ A switch-on and switch-off timer can be active concurrently.
▪ Before setting a timer, ensure that the system clock has been set to current time.
▪ Once the clock is set, the heat pump will turn on or off when the delay elapsed. When the unit is under a
timer setting, the POWER button (
use the remote control to cancel it.
▪ During timer setting, if no operation is performed for 5 seconds, the setting is canceled.
I FEEL FUNCTION
Allows the user to use the remote control as the primary temperature sensor in order for the indoor unit to
provide better comfort based on the location of the user and remote control.
Press the I FEEL button (
14
OPERATION GUIDE
) on the remote control. The symbol "
) to confirm the timer setting. The symbol "
) on the remote control. The symbol "
) to confirm the timer setting. The symbol "
) will have no effect on operation. If the timer is no longer needed,
) on the remote control to activate the function. The symbol "
" on the display screen of the re-
" will reappear on the display
) on the remote control.
" on the display screen of the re-
" will reappear on the display
) on the remote control.
" will appear