Gree Crossover GWH09AGC-D3DNA2B/I Operation Manual page 15

on the display screen of the remote control. Once activated, the remote control will transmit the ambient
temperature measured at its location to the indoor unit and the unit will automatically adjust its operation
in accordance to the transmitted temperature. Pressing the button again will deactivate the I Feel function.
Once activated, the user should keep the remote control in close proximity for the function to be effective.
The remote control should also be kept within an area where the indoor unit can receive its signal. Do not
place the remote control near high temperature appliances or devices to avoid measuring an inaccurate
ambient temperature.
CLOCK SETTING
Allows the user to set the system clock to current time.
Press the CLOCK button (
the display screen of the remote control. Use the arrow buttons (▲ or ▼) to set the time. Each press of
either button increases or decreases the time by 1 minute. Holding either button down for more than 2 sec-
onds will cause the minutes to scroll up or down more quickly. Once the clock setting is complete, press the
CLOCK button (
) to confirm. The symbol "
NOTES :
▪ Clock time adopts the 24-hour time format.
▪ If no operation is performed for 5 seconds, the setting is canceled.
SLEEP MODE
Allows the user to select a preset sleep curve or create a customized one in accordance with their needs.
Press the SLEEP button (
the button, the setting options cycle through in the following order :
Sleep 1 : In Cooling mode, one hour after the mode is set, the temperature increases by 1 °C. After two
hours, the temperature increases by another 2 °C. The unit then holds this temperature.
In Heating mode, one hour after the mode is set, the temperature decreases by 1 °C. After two
hours, the temperature decreases by another 2 °C. The unit then holds this temperature.
Sleep 2 : In this mode, the unit operates according to a group of sleep temperature curve presets.
Sleep 3 : In this mode, the user can create their own custom sleep curve by following the procedure below.
1. Hold down the TURBO button (
ization status. The remote control time display will show "
show the corresponding temperature of the last sleep curve setting and will blink (on the very first
input, the displayed temperature will be in accordance with the factory's initial curve setting).
2. Use the arrow buttons (▲ or ▼) if you wish to change the corresponding temperature setting.
OPERATION GUIDE
) on the remote control to set the time. The symbol "
" will stop blinking.
) on the remote control to select the desired sleep curve. With each press of
Sleep 1 Sleep 2
) for some time until the remote control enters user custom-
Sleep 3
OFF
(no display)
" and the temperature display will
" will start blinking on
15