Global Water GL400 User Manual page 17

For pulse sensors polarity is not an issue, so red and black wires may be inserted in either P terminals. In-
sert black/red wire into one P terminal and tighten until secure. Insert the black/red wire into the other P
terminal and tighten until secure. There is no pulse signal terminal.
pulse: P terminals
step 1: connect blue spade
lug to black terminal
Your sensor is now connected to the logger and is accessible* through the Global Logger** software pack-
age.
* See Global Logger Startup, page 18.
**Copyright © Global Water Instrumentation, Inc. 2001
Global Water ● (800)876-1172 ● www.globalw.com
step 2: connect red
spade lug to red terminal
Connect the battery's blue spade lug to
the black terminal followed by the red
spade lug to the red terminal.
Setup
Page 17