Table of Contents
Advertisement
7. For wet vacuuming, replace the cartridge filter and pre-filter with the foam filter supplied. Do not
use a dust bag when wet vacuuming. If the foam filter is not installed, refer to page 12.
8. Secure the power head back on the container, using the 2 side latches. Insert the locking end
of the hose into the suction port of the container and turn clockwise to lock into place (Fig. 5).
9. Choose the desired accessories and/or extension wands and push fit onto the hose nozzle. To
use the dusting brush and crevice tool with an extension wand you will be required to use the
metal accessory adaptor (Fig. 6).
1. Switching On/Off
Connect the mains plug to a suitable a power outlet.
Position
I
O
II
automatic synchronized start-up
2. Power Tool Take-Off Operation (Fig. 7)
WARNING:
OF THE POWER TOOL TAKE OFF SOCKET AGAINST THE DESIRED
POWER TOOL BEFORE CONNECTING TO PREVENT OVERLOADING.
1) Connect the power cable of your power tool to the power take-off socket.
2) If applicable, connect the vacuum suction hose to the dust extractor connector on your tool with
the supplied adaptor.
3) Switch the vacuum cleaner to position II, as described in Switching ON/OFF. The moment you
switch on the power tool, the vacuum cleaner will also switch on. Once the electrical appliance
has been switched off, the vacuum cleaner switches off following a time lapse (around 5
second) to allow the suction tube to be emptied.
3. Dry & Wet Vacuum Operation
WARNING!
ENTITLED 'SAFETY INFORMATION'.
1) Verify that the correct filter is installed for wet or dry vacuuming and the container latches are
secured.
2) Secure the locking end of the hose into the vacuum suction port.
3) Push the desired accessories onto the hose nozzle. The air flow regulation allows you to
change vacuum cleaner suction. For best cleaning results, fully close the air flow regulation (Fig. 8).
4) Plug the power cord into a power outlet.
5) Turn on the motor by assigning the switch to the "I" ON position.
6) Once you have completed vacuuming, switch to the "O" OFF position and unplug the power
cord from the power.
OPERATION
Status
on
off
ALWAYS CHECK THE MAXIMUM WATTAGE COMPATIBILITY
ENSURE YOU READ, UNDERSTAND AND APPLY SECTION
11
GB
Advertisement
Table of Contents
