Table of Contents
Advertisement
GB
UNPACKING AND CHECKING CARTON
1
Carry Handle
2
On/Off Switch
3
Latch
4
Rear Wheel
5
Front Caster
6
Drainage Port
7
Container
8
Suction Port
9
Power Take-off Socket
10
Power Head
11
Power Cable Hook
12
Accessory Storage
13
Blowing Port
14
Suction Hose
15
Power Tool Hose Adaptor
16
Extension Wand (x3)
NOTE: A Phillips screwdriver is required.
1. Remove all the contents from inside of the vacuum cleaner container.
2. Attach the carry handle into the slots located on the top of the power head (Fig. 1).
3. Turn the container upside down and insert the front feet with casters into the slots and apply
pressure until they click into place (Fig. 2).
4. Insert the wheel axle into the rear wheel housing on the base. Insert a washer onto the axle
followed by the rear wheel and another washer. Insert the wheel retaining pin into the hole on
the end of the axle to lock into place. Push fit the hub cap onto the wheel. Repeat the same
steps on the other end of the axle (Fig. 3).
5. Your vacuum cleaner comes ready for dry vacuum cleaning with the cartridge filter and pre-filter
pre-installed. If the cartridge filter and pre-filter are not installed, refer to page 12.
6. Optionally, for improved dust filtration, fully fit the dust bag flange onto the inlet stub (Fig. 4).
CONTENTS
17
Round Dust Brush
18
Foam Filter
19
Dust Bag
20
Crevice Tool
21
Hard Floor Nozzle
22
HEPA H13 Cartridge Filter (pre-installed)
23
Filter Retainer (pre-installed)
24
Pre-filter
25
Metal Accessory Adaptor
26
Washer (x4)
27
Hub Cap (x2)
28
Wheel Retaining Pin (x2)
29
Wheel Axle
30
Screw (x2)
31
Instruction Manual
ASSEMBLY
10
Advertisement
Table of Contents
