Maintenance - Bosch MIC IP fusion 9000i Installation Manual

MIC IP fusion 9000i
14

Maintenance

Regular maintenance of your MIC camera will preserve the MIC, especially the surface finish,
for an extended period.
Cleaning – Remove power from the device before cleaning. Generally, using a dry cloth for
cleaning is sufficient, but a moist, fluff-free cloth may also be used. Do not use liquid cleaners
or aerosol cleaners.
In corrosive environments, you should clean the camera surface periodically with fresh water.
4
–
–
Use a flow rate of 150-145 liter/minute. Hold the nozzle a minimum distance of 1 m from the
camera.
4
Note: Do not use water pressure greater than 96.5 kPa (14 psi) to wash the unit.
No User-serviceable Parts
Except for the external wiper blade, the device contains no user-serviceable parts. Contact
your local Bosch service center for device maintenance and repair. In the event of failure, the
device should be removed from site for repair.
On-Site Inspection
It is recommended that the device be inspected on-site every six months to check mounting
bolts for tightness, security, and any signs of physical damage. Inspection of this device shall
only be carried out by suitably-trained personnel in accordance with the applicable code of
practice (for example, EN 60097-17).
The following sticker appears on each side of the MIC camera head, just above the tilt arms, to
warn that the surface may be hot:
Bosch Security Systems
Wash the camera thoroughly with fresh water:
Regularly (1-2 times per quarter, or more frequently if possible)
Immediately after an event such as a sea storm that could introduce a layer salt on the
camera's surface
In certain use cases, it might help to use a solution of hydrophobic liquid to prevent long-
term buildup of salt layers on the camera's surface.
Installation Manual
Maintenance | en
2022-09 | 1.6 | F.01U.334.820
47