Table of Contents
Advertisement
FLEXIDOME IP micro 3000i - outdoor | FLEXIDOME
IP turret 3000i IR - outdoor
Multicast packet TTL
A value can be entered to specify how long the multicast data packets are active on the
network. If multicast is to be run via a router, the value must be greater than 1.
IGMP version
Set the multicast IGMP version to comply with the device.
Click Set to apply the changes.
4.7.6
IPv4 filter
To restrict the range of IP addresses within which you can actively connect to the device, fill-in
an IP address and mask. Two ranges can be defined.
4
If either of these ranges are set, no IP V6 addresses are allowed to actively connect to the
device.
The device itself may initiate a connection (for example, to send an alarm) outside the defined
ranges if it is configured to do so.
4.8
Service
4.8.1
Maintenance
Notice!
Before starting a firmware update, make sure to select the correct upload file.
i
Do not interrupt the firmware installation. Even changing to another page or closing the
browser window leads to interruption.
Uploading the wrong files or interrupting the upload can result in the device no longer being
addressable, requiring it to be replaced.
The camera functions and parameters can be updated by uploading new firmware. To do this,
the latest firmware package is transferred to the device via the network. The firmware is
installed there automatically. Thus, a camera can be serviced and updated remotely without
requiring a technician to make changes to the device on site. The latest firmware can be
obtained from your customer service center or from the download area.
Update server
The address of the update server appears in the address box.
1.
2.
Firmware
To update the firmware:
1.
2.
3.
The new firmware is unpacked and the Flash memory is reprogrammed. The time remaining is
shown by the message going to reset Reconnecting in ... seconds. When the upload is
completed successfully, the device reboots automatically.
Upload history
Click Show to view the firmware upload history.
Bosch Security Systems B.V.
Click Set and confirm to restrict access.
Click Check to make a connection to this server.
Select the appropriate version for your camera to download the firmware from the server.
First, store the firmware file on your hard disk.
Enter the full path for the firmware file in the field or click Browse... to locate and select
the file.
Click Upload to begin transferring the file to the device. The progress bar allows
monitoring of the transfer.
User manual
Configuration | en
51
2020-12 | V01 | F.01U.385.759
Advertisement
Table of Contents
