Table of Contents
Advertisement
36
en | Maintenance
8
Maintenance
8.1
Cleaning
Bubble Cleaning
If cleaning the bubble is required, use the following procedures and comply with all the
warnings listed below.
Cleaning the Bubble Interior
The extremely soft interior surface should not be cleaned by rubbing or dusting with a cloth.
Use clean dry compressed air, preferably from a spray can, to remove any dust from the
interior surface.
Warning!
Do not use alcohol-based solutions to clean the bubble. This will cause the surface to cloud
!
and, over time, cause stress aging, which makes the bubble brittle.
Cleaning the Bubble Exterior
The exterior of the bubble is hard-coated for extra protection. If cleaning becomes necessary,
only use cleaning solutions and cloths suitable for cleaning safety glass lenses. Dry the bubble
thoroughly with a dry nonabrasive cloth to prevent water spots. Never scrub the bubble with
any abrasive material or cleaners.
Bosch recommends cleaning the exterior of the bubble with NOVUS "No. 1" Plastic Clean &
Shine (or equivalent), according to manufacturer's instructions. Refer to
www.novuspolish.com
Cautions
–
–
–
–
Lens cleaning
It is important to keep the lens clean to ensure optimum performance. Dust, grease, or
fingerprints should be removed from the lens surface. When cleaning the lens, take extra care
not to damage the special coating used to reduce light reflections.
–
–
–
8.2
Repair
The unit does not contain any user-serviceable parts. Refer all repairs to suitable qualified
specialists.
8.3
Reset
To reset the camera to factory settings:
1.
2.
2023-02 | 02 |
to order or to find a local distributor.
Do not clean bubbles in the hot sun or on very hot days.
Do not use abrasive or highly alkaline cleaners on the bubble.
Do not scrape the bubble with razor blades or other sharp instruments.
Do not use Benzene, Gasoline, Acetone, or Carbon Tetrachloride on the bubble.
Remove dust with a blower-brush or grease-free soft brush.
Wipe water drops off the lens with a clean soft lint-free cloth and dry the lens surface.
Use special lens cleaning paper or cloth treated with lens cleaning fluid to gently wipe off
any remaining dirt (wipe spirally from the lens center towards the edge).
Remove the camera dome cover from the camera base.
Press the reset button on the camera base.
Installation manual
FLEXIDOME multi 7000i IR
Bosch Security Systems B.V.
Advertisement
Table of Contents
