MALTEC CH5000DWW WiFi Instruction Manual page 16

on the heater, and then press "
1. Heated 2. Day of the week 3. Mode 4. Room temperature 5. Time
The default time of the system is 12:30 on Sunday and the temperature is set to 25 °C.，
2.If you want to switch mode, press "
comfortable mode, eco mode and anti-frost mode; Each time you press the "
switch once, and loop in turn; Press "
mode, when the ambient temperature drops by 5 degrees within 10 minutes, it is
considered that the user has opened the window and the heater will stop heating and enter
standby mode.
3. Press the " " button to turn on the timing function. For the first time, "00:00" is
displayed. Press "
Continue to analogy the display as "02:00". Press once again to shut down when
displayed as "24:00";
Press the " " key for 3 seconds to set the current time. When the time is turned on, the
default is 12:30. It can be set according to the actual time.
After the first long press 3 seconds, the number of hours begins to flash, indicating that the
current time can be designed. You can set the hour by pressing the "
press the " " key again for 3 seconds, and the number at the minute begins to flash,
indicating that the current time can be set. The minute, Press the "
the minute; Press the "
seconds to exit.
4. If you want to set the temperature, press the "
setting temperature is 25 °C by default, each time press 1 °C increase or decrease, the
temperature setting range is: 10-49 °C; After setting, wait 5 seconds to show the current
ambient temperature.
When the frost-proof mode is turned on, when the ambient temperature is detected to be
less than 5 °C, the heater will automatically turn on the low-gear heating until the ambient
temperature is turned off and heated when it is greater than or equal to 9 °C, returning to
standby.
Child lock function: Press the "
" in the display shows that the child lock is turned on and all operations on the
operating panel will fail. If you want to cancel the child lock, press "
seconds. The "
normal operation.
All of the above 1-4 operations are performed when the weekly timing mode is turned off.
5. Weekly mode opening and setting
" once again ,the display as "01:00" to indicate the timing of 1 hour.
" key again for 3 seconds, to set the week ,After setting, wait 5
" and "
" in the display screen goes out and the operating panel returns to
" to display as:
" again, you can choose different modes:
" 3 seconds to open the window mode. In this
" or "
" keys at the same time for 3 seconds. The "
16/29
" or "
" or "
" key setting, the heater boot
" and "
" key,
" key,
" key to set
" for 3