Table of Contents
Advertisement
Attention
• Visit the EIZO web site for information about monitors and graphics boards that can be used for
the daisy-chain connection:
(www.eizoglobal.com)
• When using a daisy-chain connection, connect the cable to the input connector
• To set up a daisy-chain connection, you need to select "DisplayPort 1" to "Version 1.2" on the
Administrator Settings menu. For details, refer to the Installation Manual (on the CD-ROM).
• Remove the
cap before connecting the signal cable.
Connect to PC
Signal cable: PP300
2. Plug the power cord into a power outlet and the power connector on the monitor.
Insert the power cord fully into the monitor.
3. Connect the USB cable to the monitor's USB upstream port and to the PC's USB
downstream port respectively.
The cable connection is required when you use RadiCS / RadiCS LE or when you
connect a USB device (USB-connected peripheral device) to the monitor.
Attention
• When connecting the monitor to a PC on which RadiCS / RadiCS LE has been installed, connect
the cable to
.
• Remove the cap before using
Signal cable: PP300
USB cable: UU300
.
Installation / Connection | 2
.
23
Advertisement
Table of Contents
