Table of Contents
Advertisement
Notice for this monitor
Notice for this monitor
Indications for Use
This Product is indicated for use in displaying radiological images for review, analysis, and
diagnosis by trained medical practitioners. The display is not intended for mammography.
Attention
• This product may not be covered by warranty for uses other than those described in this manual.
• The specifications noted in this manual are only applicable when using the power cords provided
together with the product and EIZO-specified signal cables.
• Only use EIZO accessories products specified by EIZO with this product.
Precautions for Use
• Parts (such as the LCD panel and the fan) may deteriorate if used over extended
periods of time. Periodically check that they are operating normally.
• When the screen image is changed after displaying the same image for extended
periods of time, an afterimage may remain. Use the screensaver or power save function
to avoid displaying the same image for extended periods of time. An afterimage may
appear even after a short time period has elapsed depending on the displayed image.
To remove such a phenomenon, change the image or keep the power turned off for
several hours.
• It takes about several minutes for the monitor display to stabilize. Before using the
monitor, wait a few minutes or longer after the monitor power has been turned on or
after the monitor has recovered from the power saving mode.
• If the monitor displays continuously over a long period of time, smudges or burn-in may
appear. To maximize the life of the monitor, we recommend the monitor be turned off
periodically.
• The backlight of the LCD panel has a fixed lifetime. Depending on the usage pattern,
such as usage for long continuous periods, the lifespan of the backlight may run out
sooner, requiring replacement. When the screen becomes dark or begins to flicker,
please contact your local EIZO representative.
• The screen may have defective pixels or a small number of light dots on the screen.
This is due to the characteristics of the LCD panel itself, and is not a malfunction of the
product.
• Do not press on the LCD panel surface or edge of the frame strongly, as this may result
in display malfunctions, such as moiré patterns, etc. If pressure is continuously applied
to the LCD panel surface, the liquid crystal may deteriorate or the LCD panel may be
damaged. (If the pressure marks remain on the LCD panel, leave the monitor with a
black or white screen. The symptom may disappear.)
• Do not scratch or press on the LCD panel with any sharp objects, at this may result in
damage to the LCD panel. Do not attempt to brush with tissues as this may scratch the
panel.
• Do not touch the built-in calibration sensor (Integrated Front Sensor). Doing so may
reduce the measurement accuracy or result in equipment damage.
• Depending on the environment, the value measured by the built-in illuminance sensor
may differ from the value shown on a stand-alone illuminometer.
• Dew condensation may form on the surface or interior of this product when it is brought
into a cold room, when the temperature suddenly rises, or when it is moved from a cold
10
Advertisement
Table of Contents
