Related Manuals for Fab Fours A4160
Summary of Contents for Fab Fours A4160
- Page 1 INSTALLATION SEQUENCE HAS CHANGED. READ ENTIRE INSTRUCTION MANUAL PRIOR TO INSTALLATION!!!
- Page 2 Installation Instructions Premium Front Bumper Product Number: A4160, A4161, A4162 Application: 2017-2019 F250-F350 SAFETY Your safety and the safety of others is very important. In order to help you make informed decisions about safety, we have provided installation instructions and other information.
- Page 3 Your bumper was designed in 3-D, fabricated, and powder coated… all in the U.S.A. Enjoy the fit and finish of a quality Ford Super Duty Winch Bumper from Fab Fours Inc! Page 3 of 11...
-
Page 4: Vehicle Preparation
Installation Instructions Premium Front Bumper Product Number: A4160, A4161, A4162 Application: 2017-2019 F250-F350 II. Vehicle Preparation 1. Start by removing four bolts around tow hook on each side of vehicle. This will require an 18mm socket. 2. Next, with the help of someone holding the bumper in place, remove the four 15mm bolts from the bumper supports on both sides of vehicle. - Page 5 Installation Instructions Premium Front Bumper Product Number: A4160, A4161, A4162 Application: 2017-2019 F250-F350 3. The bumper can now be removed. (Be careful when removing bumper if vehicle has a block heater, as this will have to be unplugged during this step.) 4.
- Page 6 5. Next, using 18mm socket remove the two nuts on either side of the frame attaching frame horns to frame. Set bolt strips and nuts aside as they will be used in the installation of Fab Fours bumper. (See image.) Page 6 of 11...
- Page 7 Installation Instructions Premium Front Bumper Product Number: A4160, A4161, A4162 Application: 2017-2019 F250-F350 Page 7 of 11 A416X_MANUAL_REV_A Copyright 2008 Fab Fours, Inc...
-
Page 8: Bumper Installation
ACC Housing. For ease of installation this step should be completed prior to mounting bumper to truck. Start by installing Fab Fours mounting bracket as shown below. Do not fully tighten the hardware. OEM bolt strip... - Page 9 With the bumper in place loosely install bolt strips and hardware. Next hold the bumper into desired position on the truck. NOTE: Fab Fours recommends a MINIMUM gap of 3/8” at the outer fenders and headlights to prevent paint damage in normal operation.
- Page 10 Product Number: A4160, A4161, A4162 Application: 2017-2019 F250-F350 OPTIONAL: Trim the inner fender liners to match the higher clearance of your Fab Fours bumper. This can be done with a body saw, rotary tool, or sharp utility knife (New blade strongly recommended).
-
Page 11: Maintenance & Care
Installation Instructions Premium Front Bumper Product Number: A4160, A4161, A4162 Application: 2017-2019 F250-F350 IV. Maintenance/Care Periodically check and tighten all fasteners. Stripped, fractured, or bent bolts or nuts need to be replaced. Keep all surfaces free of dirt, road grime, and standing water to ensure finish longevity.