Table of Contents
Advertisement
Quick Links
Your safety and the safety of others is very important.
▪ In order to help you make informed decisions about safety, we have provided
installation instructions and other information.
▪ These instructions alert you to potential injury hazards.
▪ Please do a job safety analysis before each task to identify potential hazards for
your situation and remove/protect against them.
▪ You must use your own good judgment.
▪ Read and understand all safety precautions and instructions before installing
this product.
THIS PRODUCT IS FOR OFFROAD USE ONLY. ALL LIABILITY FOR
INSTALLATION AND USE RESTS WITH THE OWNER.
CARELESS INSTALLATION AND OPERATION CAN RESULT IN SERIOUS
SENSORS FIELD OF VIEW WILL BE ALTERED WITH USE OF THE
Failure to observe these instructions could lead to severe injury or death.
❑
Always remove jewelry and wear eye protection.
❑
Always use extreme caution when jacking up a vehicle for work. Set
emergency brake and use tire blocks. Locate and use the vehicle
manufacturers designated lifting points. Use jack stands.
❑
Always use appropriate and adequate care in lifting components into place.
❑
Always ensure components will remain secure during installation and
operation.
❑
Always wear safety glasses when installing this kit. A drilling operation will
cause flying metal chips. Flying chips can cause serious eye injury.
❑
Always use extreme caution when drilling on a vehicle. Thoroughly inspect
the area to be drilled (on both sides of material) prior to drilling, and
relocate any objects that may be damaged.
❑
Always use extreme caution when cutting and trimming during fitting.
❑
Always tighten all nuts and bolts securely per installation instructions.
❑
Always route electrical cables carefully. Avoid moving parts, components
that become hot and rough or sharp edges.
❑
Always insulate and protect all exposed wiring and electrical terminals.
❑ Always perform regular inspections and maintenance on mounts and
related hardware.
Copyright 2008 Fab Fours, Inc.
Installation Instructions
15 GMC HD Premium Front Bumper
Product Number: C3150, C3151, C3152
SAFETY
INJURY OR EQUIPMENT DAMAGE.
REPLACEMENT BUMPER
Injury hazard
Page 1 of 21
Application: 2015-2019 GMC HD
C315X_REV_A
Advertisement
Table of Contents
Related Manuals for Fab Fours C3150
Summary of Contents for Fab Fours C3150
- Page 1 Installation Instructions 15 GMC HD Premium Front Bumper Product Number: C3150, C3151, C3152 Application: 2015-2019 GMC HD SAFETY Your safety and the safety of others is very important. ▪ In order to help you make informed decisions about safety, we have provided installation instructions and other information.
- Page 2 Installation Instructions 15 GMC HD Premium Front Bumper Product Number: C3150, C3151, C3152 Application: 2015-2019 GMC HD Overview Congratulations on your new purchase of the industries’ best and most stylish front bumper available for the 2015 GMC Heavy Duty! This bumper has been engineered for strength while keeping the weight down.
-
Page 3: Parts List
Installation Instructions 15 GMC HD Premium Front Bumper Product Number: C3150, C3151, C3152 Application: 2015-2019 GMC HD Parts List • C315X replacement bumper • A315X brackets (20679 and 20680) • A305X-HW fastener kit • Fog lights and turn signals (61737 and 61738) •... - Page 4 Installation Instructions 15 GMC HD Premium Front Bumper Product Number: C3150, C3151, C3152 Application: 2015-2019 GMC HD Remove the fasteners connecting the grill to the frame with a 10mm socket. Four bolts are located at the top of the grill, two on each side (Ref.
- Page 5 Installation Instructions 15 GMC HD Premium Front Bumper Product Number: C3150, C3151, C3152 Application: 2015-2019 GMC HD Disconnect electrical harness (Ref. Figure 3a) from vehicle and remove tow hooks. Tow hooks are mounted with one cross bolt through the side and a bolt through the bottom of the frame (Ref.
- Page 6 Installation Instructions 15 GMC HD Premium Front Bumper Product Number: C3150, C3151, C3152 Application: 2015-2019 GMC HD Figure 3b (BOLT ACCESS FOR TOP BOLT ON MOUNTING BRACKET) Remove the fasteners connecting the OEM mounting bracket to the frame. Using a socket/wrench remove four bolts from the front of bracket connected to the bumper.
- Page 7 Remove plastic housing from OEM bumper by depressing the four plastic tabs around the inside and pushing housing out. All sensor housings will have to be placed into the Fab Fours bumper in the same location as they were removed from OEM bumper. (e.g. Outer right sensor clip must go into the outer right sensor hole in the Fab Fours bumper.)
-
Page 8: Pre-Installation
Installation Instructions 15 GMC HD Premium Front Bumper Product Number: C3150, C3151, C3152 Application: 2015-2019 GMC HD III. Pre-Installation NOTE: PLEASE READ THE ENTIRE MANUAL BEFORE ATEMPTING INSTALLATION! Ignoring these steps will increase your probability of scratching the vehicle and damaging the sensors during product installation. - Page 9 Installation Instructions 15 GMC HD Premium Front Bumper Product Number: C3150, C3151, C3152 Application: 2015-2019 GMC HD Page 9 of 21 C315X_REV_A Copyright 2008 Fab Fours, Inc.
- Page 10 15 GMC HD Premium Front Bumper Product Number: C3150, C3151, C3152 Application: 2015-2019 GMC HD Install the provided Fab Fours fog lights using the provided hardware kit. The wiring diagram for the fog lights can be found in section V.
-
Page 11: Front Bumper Installation
Installation Instructions 15 GMC HD Premium Front Bumper Product Number: C3150, C3151, C3152 Application: 2015-2019 GMC HD Figure 7 • Optional: If installing winch and roller fairlead into bumper, do it after sensors have been installed. Follow the winch manufacturer’s instructions for installation. - Page 12 Allow clearance to all painted surfaces, this is to allow for frame flex. Fully tighten all fasteners between bumper and bracket. Enjoy your New Front Replacement Bumper from Fab Fours! Page 12 of 21 C315X_REV_A...
- Page 13 Installation Instructions 15 GMC HD Premium Front Bumper Product Number: C3150, C3151, C3152 Application: 2015-2019 GMC HD Fog Light and Turn Signal Wiring 1. Disconnect the battery of your truck. 2. With a flathead screwdriver, remove pins attaching upper shroud. Remove the shroud.
- Page 14 Installation Instructions 15 GMC HD Premium Front Bumper Product Number: C3150, C3151, C3152 Application: 2015-2019 GMC HD FAB FOURS TURN INDICATOR WIRING WHITE WIRE = GROUND BROWN WIRE = RUNNING RED WIRE = TURN FAB FOURS FOG LIGHT WIRING WHITE WIRE = GROUND...
- Page 15 Installation Instructions 15 GMC HD Premium Front Bumper Product Number: C3150, C3151, C3152 Application: 2015-2019 GMC HD Connect headlight and wires and fog light/turn signal wires. Reattach headlight pods to truck Install turn indicators into the plastic light insert using three self-tapping screws as shown below.
- Page 16 15 GMC HD Premium Front Bumper Product Number: C3150, C3151, C3152 Application: 2015-2019 GMC HD Figure 13a Install the Fab Fours fog lights into the mounting brackets as shown below using the #8 button head screws, washers, and hex nuts. Figure 14a...
- Page 17 Installation Instructions 15 GMC HD Premium Front Bumper Product Number: C3150, C3151, C3152 Application: 2015-2019 GMC HD 13. Install the fog light and bracket into the bumper using the remaining two holes. 14. Install turn indicators into the plastic light insert using three self-tapping screws as shown below.
- Page 18 15 GMC HD Premium Front Bumper Product Number: C3150, C3151, C3152 Application: 2015-2019 GMC HD Install the Fab Fours fog lights into the mounting brackets as shown below using the #8 button head screws, washers, and hex nuts. Figure 14a...
-
Page 19: Maintenance & Care
Installation Instructions 15 GMC HD Premium Front Bumper Product Number: C3150, C3151, C3152 Application: 2015-2019 GMC HD VI. Maintenance/Care ❑ Periodically check and tighten all fasteners. ❑ Stripped, fractured, or bent bolts or nuts need to be replaced. ❑ After washing of the vehicle make sure to fully dry all surfaces... -
Page 20: Appendix A. Troubleshooting Vehicle Sensors
Installation Instructions 15 GMC HD Premium Front Bumper Product Number: C3150, C3151, C3152 Application: 2015-2019 GMC HD APPENDIX A. Troubleshooting Vehicle Sensors • Start with a general inspection of the sensor fitment. Check that both the sensors and the sensor clips are fully secure and the sensors are properly centered in the housing. -
Page 21: Contact Information
Installation Instructions 15 GMC HD Premium Front Bumper Product Number: C3150, C3151, C3152 Application: 2015-2019 GMC HD VII. Contact Information Fab Fours Inc. Phone (866)-385-1905 1312 Camp Creek Rd (866)-574-1424 Lancaster, SC 29720 Email Support@fabfours.com More than expected… Better than expected...