Dxe-Arav3-2P Two Active Receivers; Dxe-Arav3-4P Four Active Receivers; Dxe-Arav3-8P Eight Active Receivers; Warning - DX Engineering DXE-ARAV3-1P Manual

DXE-ARAV3-2P -
used with the optional DXE-NCC-1 Noise/Phase Controller to make a steerable dual vertical array.
The NCC-1 can also provide power for the active antennas and the proper transmit power-off
sequencing.

(2) Non-conductive mounting plates

(2) Solid brass element mounting blocks

(2) High quality, 102 in. tapered stainless steel whip antenna elements

(2) AVA-2 Active matching systems w/ Internal Antenna Disconnect Relays

(2) Element connection wires

(2) Sets of Stainless steel clamps and hardware
DXE-ARAV3-4P -
use with the optional DXE-RFS-3P Receive Four-Square system to build a Four-Square Receiving
Array. The RFS-3P which has provision for powering the active antennas

(4) Non-conductive mounting plates

(4) Solid brass element mounting blocks

(4) High quality, 102 in. tapered stainless steel whip antenna elements

(4) AVA-2 Active matching systems w/ Internal Antenna Disconnect Relays

(4) Element connection wires

(4) Sets of Stainless steel clamps and hardware
DXE-ARAV3-8P -
use with the optional DXE-RCA8-SYS-4P Receive Eight Circle system to build an Eight Circle
Receiving Array. The RFS-3P which has provision for powering the active antennas

(8) Non-conductive mounting plates

(8) Solid brass element mounting blocks

(8) High quality, 102 in. tapered stainless steel whip antenna elements

(8) AVA-2 Active matching systems w/ Internal Antenna Disconnect Relays

(8) Element connection wires

(8) Sets of Stainless steel clamps and hardware
The DXE-ARAV3 active antennas may be used in installations when spacing from transmit
antennas is less than 1/2-wavelength but more than 1/10-wavelength (on the lowest frequency). The
ARAV3 active vertical antenna grounds the antenna element when power is turned off. Ideally,
receive antennas should be over 1/2 wavelength from transmit antennas.
A DXE-TVSU-1A Time Variable Sequencer Unit should be used to ensure the correct transmit to
receive switching.

WARNING!

INSTALLATION OF ANY ANTENNA NEAR POWER LINES IS DANGEROUS
The two active antennas system package DXE-ARAV3-2P is intended to be
The four active antennas system package DXE-ARAV3-4P is intended for
The eight active antennas system package DXE-ARAV3-8P is intended for
- 5 -