Boss EQUALIZER Maintenance Manual page 17

BOSS HD Equalizer Til t System
Boss HD Equalizer Leg Support Adjustments
Tools needed: 7/16" wrench
a) Leg Support Length (Custom Lengths Available. For More Details Call 1-800-255-0285)
The center tubes can telescope in and out to to change the overall length of the center column leg rest.
To adjust the length simply remove the two nuts and bolts then move the tubes to the desired hole and
put the bolts back through and tighten the nuts with an allen wrench and 7/16" wrench.
b) Elevating the Foot Plate Column Angle
The center mounted leg rest has a series of holes that allow you to pivot the leg support at different
angles and lock it into place. To adjust this angle simply pull the pin out of the hole that it is currently in
and lift or lower the leg rest the desired angle. Then insert the pin into the nearest hole.
c) Footplate Angle
The angle of the footplate can be adjusted using the bolts on the bottom of the footplate. Use 7/16"
wrenches to loosen the nuts and set the bolt to stop the footplate at the desired angle, then tighten both
nuts.
Back angle adjustment
The angle of the back canes can be adjusted or folded fl at for easy
transport by removing the wing nut found on the fastener near the base
of the back cane. Each set of holes sets the back at a different angle
o
in 4 increments. Leave the top pivot bolt in place as you adjust the
back angle.
16