Advertisement
First, in order to check the current status of the service code parameter, out put the setup list
(code: 991) and service list (code: 999) from the customer's fax machine. Based on this, the
parameters for the desired codes can be changed. The procedure for changing and listing
parameters is described on
ENTERING THE REMOTE PROGRAMMING MODE AND CHANGING
SERVICE CODES
(). Also, before exiting the remote programming mode, it is advisable to obtain
a new list to confirm that only the desired parameters were changed.
Hint:
Since the connected telephone is in use during the remote programming mode, it may be
helpful to ask the customer to switch to the speakerphone (except for a digital speakerphone).
This frees the customer from the need to remain right next to the fax while you are making
parameter settings. When finished, inform the customer. Also note that in very noisy locations
where the DTMF tones are not audible, the remote programming function will not work.
2.3.5.2.1. ENTERING THE REMOTE PROGRAMMING MODE AND CHANGING SERVICE CODES
CROSS REFERENCE:
PROGRAM MODE TABLE
()
71
Advertisement
