Table of Contents
Advertisement
Installation
Accessories
1
1 x
2
1 x
3
1 x
4
2 x
5
1 x
6
2 x
7
1 x
8
6 x
9
1 x
:
2 x
Caution!
The use of any accessories except for those provided might result in damage to the unit. Make sure only to use the
accessories shipped with the unit as shown above.
28
Installation Procedure
1. To prevent short circuits, remove the key from the
ignition and disconnect the ground terminal of the
battery.
2. Make the proper input and output cable connec-
tions for each unit.
3. Connect the wiring harness cables in the following
order: ground, battery, ignition.
4. Connect the wiring harness connector to the unit.
5. Install the unit in your car.
6. Reconnect the 63 terminal of the battery.
7. Press the reset button. (See p. 4)
Caution!
•
If your car's ignition does not come with an ACC
position, connect the ignition cables to a power
source that can be turned on and off with the igniti-
on key. If you connect the ignition cable to a power
source that receives a constant voltage supply, as
with battery cables, the battery may die.
•
If the fuse blows, first make sure that the cables
have not caused a short circuit, then replace the
old fuse with one with the same rating.
•
Do not let unconnected cables or terminal touch
metal on the car or anything else conducting elec-
tricity. To prevent short circuits do not remove the
caps from unused terminals or from the ends of the
unconnected cables.
•
After the unit is installed, check whether the brake
lamps, blinkers, wipers, etc. on the car are working
properly.
•
Insulate unconnected wires with vinyl tape or other
similar material.
•
Mount the unit so that the mounting angles is 30º
or less.
Advertisement
Table of Contents
