Indicators; Led Indicators; Beeper - Datalogic Lynx Instruction Manual

GETTING STARTED
1.6

INDICATORS

1.6.1

LED Indicators

The following LED indicators signal the reader functions.
LED
Red
(Figure A,1)
Green
(Figure A,2)
1.6.2

Beeper

The Lynx™ basic software provides beeper signals for good/wrong reading or
successful/unsuccessful software upgrade. Its tone, volume and duration can be
directly configured by using the codes given in par. 2.11.
The application program can also manage the beeper (User Defined Beeper) when
the reader is controlled by a Host PC. It is possible to activate the beeper by sending
a command from the Host to the reader via the current communication interface.
The codes given in par. 2.11.1 allow defining the beeper properties.
The configuration of the User Defined Beeper does not influence or
change the functioning of the beeper managed by the Lynx™ basic
software.
NOTE
Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
Reader Power On
lights until a beep occurs.
Then, it turns off.
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France
Behavior
Normal Functioning
lights when a wrong read
occurs.
lights for the entire time the
aiming system is enabled. It
turns off only when the trigger
is released and the aiming
system is disabled.
lights when a symbol has
been read and decoded.
1
13