Table of Contents
Advertisement
With some problems, the display shows an alarm message and
the Start/Pause button may flash continuously:
If the appliance is overloaded, remove some items
from the drum and/or keep pressed the door while
touching the Start/Pause button until the indicator
stops flashing (see the picture below).
Problem
Check that the water
inlet tap is open:
The appliance does
not fill with water prop‐
erly.
Check that the drain
filter is not clogged:
The appliance does
not drain the water.
Check that the door
is properly closed:
The appliance door is
open or not closed
correctly.
Possible solution
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not too low.
For this information, contact your local water authority.
•
Make sure that the water tap is not clogged.
•
Make sure that the inlet hose has no kinks, damages or
bends.
•
Make sure that the connection of the water inlet hose is cor‐
rect.
•
Make sure that the filter of the inlet hose and the filter of the
valve are not clogged. Refer to 'Care and cleaning'.
•
Make sure that the sink spigot is not clogged.
•
Make sure that the drain hose has no kinks or bends.
•
Make sure that the connection of the drain hose is correct.
•
Set the drain program if you set a program without drain
phase. If the drain program is not available in the pro‐gramme
dial, it can be set via App.
•
Set the drain program if you set an option which ends with
water in the tub.
•
Make sure that the door is properly closed.
ENGLISH
57
Advertisement
Table of Contents
