AEG LWX9A9613C User Manual page 39

If the ProSense phase is
already carried out and the
water filling is already
started, the new program
starts without repeating the
ProSense phase. The water
and the detergent are not
drained out in order to avoid
waste.
14.13 Opening the door
If the temperature and level
of the water in the drum are
too high and/or the drum still
rotates you cannot open the
door.
If is on: the water
temperature and level are
not high and it is still
possible to open the door
and add clothes.
While a program or the delay start
operates, the appliance door is locked.
1. Touch the Start/Pause button .
In the display the related door lock
indicator goes off.
2. Open the appliance door. If
necessary, add or remove the items.
3. Close the door and touch the Start/
Pause button.
The program or the delay start continues.
14.14 End of the program
When the program has finished, the
appliance stops automatically. The
acoustic signals operate (if they are
active).
The display tells that the cycle is finished
and shows 0h00min.
The Start/Pause button goes off.
The door unlocks and the indicator goes
off.
1. Press the On/Off button to deactivate
the appliance.
After five minutes after the end of the
program, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
shows the end of the last
selected program. Turn the
program dial to set a new
cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door and the detergent
dispenser slightly ajar to prevent
mildew and odours.
5. Close the water tap.
14.15 Draining water out after
end of cycle
If you have chosen a program or an
option that does not empty out the water
of the last rinse, the program is
completed, but:
• The display shows 0 min and the
Start/Pause button starts flashing.
• The drum still turns at regular
intervals to prevent the creases in the
laundry.
• The indicator
door stays locked.
• You must drain the water to open the
door:
1. Touch the Start/Pause button:
• If you have set
drains the water and spins.
• If you have set
only drains the water.
2. If necessary, change the spin speed
proposed by the appliance: touch the
Start/Pause button to pause the
program; tap on
Spin Speed bar.
3. When the program is completed and
the door locked indicator
goes off, you can open the door.
4. Press the On/Off button for a few
seconds to deactivate the appliance.
In any case, the appliance
empties the water out
automatically after
approximately 18 hours.
ENGLISH 39
is still on and the
, the appliance
, the appliance
and then on the