Flicker Motor Replacement - Dimplex PLF3614-XS Service Manual

Flicker Motor Replacement

Tools Required: Phillips Head Screwdriver
Side Cutters
1. Follow the instructions for Preparing the Firebox for Service on page 6.
2. Remove the 2 screws on each side of the bottom panel (4 total). Disconnect the LED connection, and set the bottom
panel aside. (Figure 17)
3. Remove the 2 screws that secure the flicker motor bracket. (Figure 18)
4. Disconnect the flicker motor from the flicker rod.
5. Remove the 2 screws that secure the flicker motor to the flicker motor bracket. (Figure 19)
6. Cut the wire ties from the bundle of wires that include the flicker motor wires.
7. Disconnect the flicker motor connection on the main control board, and connect the connector from the new flicker
motor.
8. Secure the new flicker motor to the flicker motor bracket.
9. Insert the stick of the flicker motor in the rubber grommet from the flicker rod.
10. Secure the flicker motor bracket to the firebox.
11. Secure the previously bundled wires using the previously removed rubber sleeve and the provided wire ties.
12. Secure the bottom panel, ensuring that the LED is reconnected through through the square opening.
13. Reassemble firebox.
Figure 17
Figure 19
Figure 18
13