Table of Contents
Advertisement
Temperature Sensor (NTC) Replacement
Tools Required: Phillips Head Screwdriver
Side Cutters
1. Follow the instructions for Preparing the Firebox for Service on page 6.
2. Remove the 2 screws on the NTC bracket. (Figure 16)
3. Trace the NTC wire to the main control board.
4. Disconnect the NTC and remove it, cutting any restrictive wire ties. Make note of the location of the NTC connector.
5. Feed the connector from the new NTC toward the main control board, and connect it into the correct location.
6. Secure the new NTC on the NTC bracket using the provided wire tie.
7. Secure the bracket using the 4 screws previously removed.
8. Reassemble the fireplace, ensuring the NTC wire is secured away from the mirrored glass when re-installing it.
Figure 16
NTC Bracket
12
www.dimplex.com
Advertisement
Table of Contents
