Table of Contents
Advertisement
If you need to remove the drawers with ball bearing slides from the unit, please
follow the steps below to prevent any damage to the slides or the drawers.
1. If you need to remove the drawer, please pull the drawer all the way out, then
simultaneously push the plastic release lever of the ball bearing slide up on one side
and down on the other side, and then pull the drawer completely out. See detail A.
2. To place the drawer back, simply push the ball bearing cart all the way to the end of
the slides (in both sides), and align the slide runners on the drawer with the slide tracks
on the unit and push it carefully inside until it stops. See detail B.
NOTE: If the drawer does not go in smoothly, please take it out and repeat the step.
DRAWER INSTALLATION
3
Advertisement
Table of Contents
Need help?
Do you have a question about the HOCSFC-13AX and is the answer not in the manual?