Table of Contents
Advertisement
14 Tighten the stapler head blade clamping screw.
15 Add new staples.
16 Repeat steps 3 through 15 in this procedure to reposition
other stapler heads, if necessary.
17 Place the stapler head screwdriver back in its storage location.
The following three adjustments must be made on Trimmer to change
the booklet format.
Adjust the trimming position
Adjust the offsets
Adjust the conveyor wheel
The long side of a booklet becomes jagged when folded, so the Trim-
mer trims it to make the booklet pages neater and easier to flip
through. Use the following procedure to adjust the trimming position.
1
Roll the Trimmer away from Folder/Stapler.
WARNING! The QMS 4060 Print System, Folder/Stapler, and
Trimmer are connected with electrical cables. Make sure all of the
cables are unplugged before moving one or more of these units.
Always switch off and unplug the Trimmer before moving it away
from the QDOC Bookletmaking System.
ACHTUNG! Das QMS 4060 Print System, Falz-/Heftsystem und
der Trimmer sind durch Kabel verbunden. Vergewissern Sie sich,
daá alle Kabel abgezogen sind, bevor Sie die Geräte
verschieben. Schalten Sie den Trimmer immer aus und ziehen
Sie die Kabel ab, bevor sie ihn vom QDOC Booklet System
wegschieben.
Advertisement
Table of Contents
