QMS QDOC User Manual page 100

Use this method to configure the printer if you're printing booklets
from a PostScript file. Open the PostScript file as a text file and
include the following DOCs at the beginning of the file before
sending the file to the printer. For more information on using
DOCs, refer to the QMS Document Option Commands manual (in
Adobe Acrobat format on the QMS Software Utilities CD ROM).
%%IncludeFeature: input ( value )
Explanation
Valid values
Example
%%IncludeFeature: output ( value )
Explanation
Valid values
Example
%%IncludeFeature: pagesize ( value )
Explanation
Valid values
Example
Note
Identifies the input source for the booklet media
lower, middle, upper
%%IncludeFeature: input (lower)
Identifies the output location for the booklet
2 (the Folder/Stapler)
%%IncludeFeature: output (2)
Identifies the logical page size of the booklet
A4, A5, B4, B5, executive ledger, legal, letter,
statement
%%IncludeFeature: pagesize (letter)
Your selection here depends upon the page
size used in your application and your final
booklet size. If you are creating 5.5" x 8.5"
booklets and your document was created
using statement size (5.5" x 8.5"), then you
should select Statement here. If your
document was created using letter size (8.5" x
11"), then you should select Letter 8.5 x 11 in
and then use the %%IncludeFeature:
pagescaling (on) command.