Compaq ProLiant 6000 Series Setup And Installation Manual page 92

Open the ejector levers
on the processor terminator board and remove
4.
it by pulling it out by the handle . Retain for future use.
NOTE: If you remove a processor, the processor terminator board must be
re-installed before powering up the server.
Figure 4-8. Removing the processor terminator board
5. Locate the processor bus/core ratio switch for the processor socket that
will receive the new processor. See Table 4-1 or the right side access
panel label.
6. Set the processor bus/core ratio switch to the appropriate setting.
Processor Bus/Core Ratio Switch Settings
Bus/Core Ratio
400-MHz models
450-MHz models
500-MHz models
550-MHz models
NOTE: Compaq makes no representation or warranty that processors that operate at any
of the speeds shown will be available at any time.
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
1
2
Table 4-2
1
ON
OFF
ON
OFF
Compaq ProLiant 6000 Setup and Installation Guide
1
2 3 4
ON ON OFF
ON ON OFF
ON OFF OFF
ON OFF OFF
4-9