Contents Of The Mounting And Installation Instructions; Changes And Alterations To The Equipment; Responsibility Of The Operating Entity; Personnel Requirements - Eaton DualGuard-S ESF30 Mounting And Operating Instructions

2.2 Contents of the mounting and installation
instructions
Any person authorised to carry out work on or with the
equipment must have read and understood the operating
instructions before commencing work on the equipment.
This also applies if the person concerned has worked with
the same or similar equipment in the past or was trained by
the manufacturer.
2.3 Changes and alterations to the equip-
ment
In order to avoid hazards and to ensure the best possible
performance, no modifications, retrofits and add-ons are
permitted on the equipment unless these were expressly
approved by the manufacturer.

2.4 Responsibility of the operating entity

These operating instructions must be kept in the direct
vicinity of the equipment and must always be accessible to
people working on or with the equipment. The equipment
must only be operated if it is in an exemplary and operationally
safe condition. The equipment must be checked every time
before it is put into operation. The operating instructions as
set out in the manual must be complied with in full!

3 Technical Data

Tabelle 1: Technical Data
DualGuard-S
Typ
ESF30 30P
Approval empty enclosure /
Certificates DIBT
Empty enclosure
Fire exposure from outside 30
(min)
Enclosure specifications
Enclosure Fibre plates
Protection rating IP42
Protection class l
Dimensions 2115 x 898 x 549
(H x W x D in mm)
Weight (kg) empty cabinet 330
Closure Sash fastener
Electronic specifications
Rated voltage 400 V 50 Hz
Number of module slots 0-30
Max. conductor size / final 4
circuits (mm²)
Max. conductor size (mm²) 35
Max. total conductor 775
size (mm²)
Mounting and Operating Instructions Fire-Resistant Cabinet Type DualGuard-S ESF30 October 2022 www.eaton.com

2.5 Personnel requirements

Only authorised and qualified personnel may carry out
work on or with the device. These personnel must have
been trained in possible hazards that may occur. A qualified
person is anyone who, based on his/her training, expertise
and experience as well as his/her knowledge of the relevant
provisions, is able to assess the work that he/she has been
given and to identify any potential hazards.

2.6 Work safety

Following the safety information and instructions provided in
this operating manual is essential to avoid bodily injuries and
property damage while working on and with the equipment.
DualGuard-S DualGuard-S
ESF30 15P ESF30 SOU5
DIBT VDE
30 30
Fibre plates External fibre plates
/ Internal plastic
IP42 IP65
l l
1265 x 898 x 449 1135 x 396 x 230
187 81
Sash fastener Sash fastener
230 V 50 Hz 230 V 50 Hz
0-15 5
4 4
35 10
625 89
DualGuard-S DualGuard-S
ESF30 SOU3 ESF30 SOU2
VDE VDE
30 30
External fibre plates External fibre plates
/ Internal plastic / Internal plastic
IP65 IP65
l l
835 x 396 x 230 685 x 396 x 230
61 51
Sash fastener Sash fastener
230 V 50 Hz 230 V 50 Hz
3 2
4 4
10 10
79 74
2 Safety
DualGuard-S
ESF30 SOU1
VDE
30
External fibre plates
/ Internal plastic
IP65
I
535 x 396 x 230
35
Sash fastener
230 V 50 Hz
1
4
10
39
5