Klarstein VERBIER 10034396 Manual page 26

EN
26
(4) Set the shutdown time
1 Press the "TIME SET" button, the display is off, and the hour starts blinking.
2 Press the "+" or "-" button to adjust the hour.
3 Continue to press the "TIME SET" button, the minute starts blinking.
4 Press the "+" or "-" button to adjust minute.
(5) Set temperature
Then press the "TIME SET" button, and the temperature setting starts blinking. Then
you can adjust the temperature by pressing "+" or "-". The "+" button will raise the
temperature, and the "-" will lower the temperature.
Press "TIME SET" button to continue setting, and press "OK" to complete the setting.
Important Notes on Timer
• TIME ON/OFF is to control the timer opening and closing
• Note 1: Restart the machine after the power is cut off, the original setting is kept,
but the date and time must be reset.
• Note 2: When the week timer is power on, you should turn on the heating function,
or else when the machine is working again as the timer, there will be only the flame
effect working.
Safety Cut-Off
This appliance is fitted with a safety cut-off which will operate if the fire overheats (e.g.
due to blocked air vents). For safety reasons, the fire will NOT automatically reset.
To reset the appliance, disconnect the appliance from the mains supply for at least
15 minutes. Reconnect to the mains supply and switch on the appliance.
Troubleshooting
Symptom
No operation/no fan.
No fire effect light.
Solution
Check fuse by replacement.
Check for safety cut-off operation.
Check the bulb by a qualified electrician.