General Use - Klarstein VERBIER 10034396 Manual

GENERAL USE

Note: The appliance can be operated either by the switches located at the bottom
left hand side of the fire or by the supplied remote control.
Manual Operation
• This is done by operating the switches located at the bottom left hand side of the
fire. The standby rocker switch must first be switched on, the fire will beep to indicate
that it is powered up.
• Press the O/I button once to turn on the appliance and fire effect. A red indicator
light will show to indicate that the fire is ON. Press the O/I button for 3 seconds this
will operate the dimmer mode, hold the button down until the desired brightness is
obtained.
• Press once the 1000W button for the low heat settings; press twice to switch off the
heat setting.
• Press once the 2000W button for the low heat settings; press twice to switch off the
heat setting.
Remote Operation
The standby rocker switch located at the bottom left
hand side of the fire must first be switched on; the fire
will beep to indicate that it is powered up.
It takes a little time for the receiver to respond to the
transmitter. Do not press the buttons more than once
within two seconds for the fire to operate normally.
EN
21