Set Up - Graco ToughTek MP-Series Operation Manual

Set Up

Set Up
NOTE: For letter references, see the Component
Identification section, starting on page 5.
1. Assemble the drive/mix shaft (D) into the hopper
and engage the flat end as shown below into the
slot of the rotor (RS).
A
2. Slowly swing the motor assembly toward its closed
position, stopping shortly before the motor shaft
adapter (MS) and drive/mix shaft (D) touch.
8
3. Make sure the motor shaft adapter (MS) and
drive/mix shaft (D) are aligned so the drive shaft flat
slides into the motor shaft adapter slot. If they do not
align, rotate them into position.
4. Swing the motor completely shut and lock it in place
with the motor latch (K).
3A4349B