Troubleshooting - Summit FF1DSS User Manual

Frost-free drawer refrigerators
Table of Contents

Advertisement

You can solve many common problems easily, saving you the cost of a service call. Try the
suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM
Appliance is not connected to a
power supply.
Appliance
does not
The appliance is turned off.
operate.
Tripped circuit breaker or blown fuse
The temperature is not set correctly.
The ambient temperature could
require a lower temperature setting.
Drawers were opened too often.
Appliance is
A drawer was not closed completely.
not cold
Drawer is not hermetically sealed.
enough.
The condenser is too dirty.
The ventilation opening is blocked or
too dusty.
The room temperature is higher than
average.
A large amount of food has been
added to the unit.
Appliance
turns itself on
and off
Drawers are opened too often.
frequently.
A drawer is not closed completely.
A drawer gasket does not seal
properly.
Appliance is not connected to a
power supply.
The light does
Tripped circuit breaker or a blown
not work.
fuse.
The light was switched off on the
control panel.
The appliance is not properly leveled.
Vibrations
The rattling noise may come from the flow of the refrigerant, which is normal. As
each cycle ends, you may hear gurgling sounds caused by the flow of refrigerant
in your appliance.
The appliance
If temperature fluctuations occur, the contraction and expansion of the inner walls
makes too
may cause popping and crackling noises.
much noise.
The appliance is not properly leveled.
Drawer
The appliance is not properly leveled.

TROUBLESHOOTING

Troubleshooting Guide
POSSIBLE CAUSE
Connect the appliance.
Switch on the appliance.
Switch on circuit breaker or replace
fuse.
Check the set temperature.
Set a lower temperature.
Do not open drawers more often
than necessary.
Close drawer properly.
Check the seal and clean or replace
it.
Clean the condenser when
necessary.
Clear the obstructions and clean off
the dust.
Put the appliance in a cooler place.
Leave the appliance to work for a
while until the set temperature has
been reached.
Do not open the drawers more
often than necessary.
Close drawer properly.
Check the drawer seal and clean or
replace it.
Connect the appliance.
Switch on circuit breaker or replace
fuse.
Switch on the light.
Level the appliance with adjustable
feet.
Level the appliance with adjustable
feet.
Level the appliance with adjustable
14
REMEDY

Advertisement

Table of Contents
loading

Table of Contents