Summit FF1DSS User Manual page 15

will not close
properly.
The gaskets are dirty.
The racks or bins are out of position.
"E0" indicates a communication error
for 3 zone models.
Display "E0", "E1" or "E2" indicates that the air
"E1". "E2", temperature sensor has failed.
"E3", "E4",
"E5" or "E7".
sensor in the evaporator has failed.
"E5" indicates defrost heater failure.
"E7" indicates door switch failure.
Has a drawer been open for longer than
60 seconds? If not, then the
temperature has risen higher or fallen
lower than the temperature that has
The alarm
been set. This could be due to:
sounds and
The appliance drawers are being
the
opened too often.
temperature
The ventilation opening is covered or
display
too dusty.
flashes.
A lengthy interruption in the power
supply.
A large amount of food has been
added to the unit.
The icon "--"
The displayed temperature is out of
is lit and
range.
flashing in the
temperature
display.
If you have checked the table above and find that you still need help with your appliance, call our
Customer Service facility at 800-932-4267 between 9:00 AM and 5:00 PM ET. We will do our best to
answer your questions.
CALIFORNIA CARB/SNAP DISCLOSURE
This product uses eco-friendly hydrocarbon refrigerant and fully complies with California
CARB regulations.
However, we are required by California Law to provide the following disclosure statement in every
product sold in California.
"This equipment is prohibited from use in California with any refrigerants on the 'List of Prohibited
Substances' for that specific end-use, in accordance with California Code of Regulations, title 17,
section 95374. This disclosure statement has been reviewed and approved by Felix Storch, Inc. and
Felix Storch, Inc. attests, under penalty of perjury, that these statements are true and accurate."
This product does not use any refrigerants on the List of "Prohibited Substances".
"E3" or "E4" indicates that the defrost
feet.
Clean the drawer gaskets.
Check the racks and bins and refit
them correctly.
Call for service.
If yes, close the drawer.
Do not open drawers more often
than necessary.
Clear the obstructions and clean off
the dust.
Leave the appliance to work for a
while until the set temperature has
been reached.
Only temperatures within the range
0~99°F/-9~37°C can be displayed.
If the temperature is not within this
range, the icon "--" will be displayed
instead. This is normal.
15