Use - Cebora 334 Instruction Manual

Max current I1eff consumed can be deduced by reading the technical data on the device against available supply
voltage U1.
The cross-section of any extensions must comply with maximum current consumption I1eff.
4

USE

When the device is turned on by means of knob B, the display N shows:
For Item No 334-336
Information
Power Source
Version panel
Version control
Torch CP162C MAR 6m
- power source item number;
- firmware version installed in the panel board
- firmware version installed in the control board
- type of torch fitted
(CP 70C MAR/DAR; CP 162C MAR/DAR)
- length of the welding torch when fitted (6/15 m)
For Item No 337
Information
Power Source
Version
Build
Torch CP162C MAR 6m
- power source item number;
- installed firmware version;
- firmware development date,
- type of torch fitted;
- length of the fitted welding torch
Note: torch type and length are automatically recognised. A few seconds later, display N shows one of the screens de-
scribed below.
In general, knob H is used to select the various items, namely:
- CUT, SELF RESTART,
- working current;
- working pressure;
- cutting gas;
- material
Press knob H on the individual item selected. It will then become bold and the item can be changed.
36
336
04
01
337
04
Feb 20 2017
GOUGE and SPOT MARK working modes
;
;