Mitsubishi Electric i-BX-N Technical Manual page 13

TM_i-BX(-N)_NC05_00_06_20_EN
[Only visible with the Installer or Service password - only for i-BX-N and if the domestic hot water function has been enabled]
○,1 ○,6
Temperature difference between
○,2
Domestic water temperature setpoint
○,3
DHW pump status
- Off
- Manual
- On
Sniffer
-
- En.boost - In COOL + DHW (both DHW and system priority) or HEAT + DHW (DHW
priority), if there is system request and no DHW request the "En.boost" message
appears
- Act.boost -> Same condition as above, in addition to others regarding parameters
0208-0209-0210-0611-0612, but in this case, in addition to the appearance of the
message, the DHW pump starts at maximum speed
- Sn.Freeze – Antifreeze Sniffer
- Max T - Forcing of overboost due to setpoint not reached
- Max set - Temperature very far from the setpoint
○,4
Temperature difference
[Only visible with the Installer or Service password - only for i-BX-N and if the BT9 probe has been enabled - parameter 0314 = YES]
○,1
Water temperature setpoint
○,2
Unit output water temperature
[Menu only accessible with the Service password. By pressing ENTER and using the UP and DOWN keys, it is possible to access all the information managed by the Power+ driver]
MEHITS S.p.A. ● TECHNICAL MANUAL
DHW management information
○,5
and
Inertial storage tank information
Inverter Power+/compressor information
○,5
Unit input water temperature
○,6
DHW storage tank temperature
○,7
Unit output water temperature
○,8
Storage tank heater status
Storage tank heater NOT
active
○,3
Storage tank internal water temperature
○,4
Unit input water temperature
13
Version NC05 - Translation of the Original Instructions
Storage tank heater not
active