Factory Defaults; Maintenance; Cleaning; Replacing The Battery - Fluke 52801RJ9 User Manual

After you dial the ANAC number and get a response,
the phone number of the line pair that the test set is
connected to is shown on the display. If the ANAC
response is greater than 10 digits, the last 10 will be
displayed. The test set is automatically muted in visual
ANAC mode. If a visual response is not available, an
audible response is given.
You can also enter the ANAC number in speed dial
location 9 and the test set automatically enters Visual
ANAC mode when the speed dial is used. If a visual
response is not available, an audible response is given.
Use one of the other speed dial locations (0-8) if you
always want an audible response.
ANAC mode is turned off when you switch to Monitor
mode. If ANAC mode is off, the ANAC voice response is
audible on the handset or speaker.

Factory Defaults

The Restore Defaults function lets you restore all
programmable features to their original factory
settings. This function does not clear stored telephone
numbers. The defaults are:

Hook Flash: 600 ms

Speaker timeout: 2 minutes

Speakerphone: enabled

Receive-Only Loud Speaker: disabled

Backlight: off

DTMF Digit Grabbing: off

Monitor Mode timeout: 2 minutes
To restore the factory default values:
Set the Talk/Monitor switch to M.
1
Press the STORE/PROG key.
2
Press the pound (#) key. The test set gives a
3
confirmation tone when the entry is accepted.

Maintenance

W
Warning
Disconnect the test set's alligator clips from
any metallic connections before performing
any maintenance. Read all instructions
completely and understand possible hazards
to end user if repairs are not performed
properly.
Batteries are hazardous to handle. Do not
allow the terminals to be shorted together.
Severe burns or explosion can result if not
handled properly. Dispose of the battery
properly to ensure contacts cannot short.
Disposal may be restricted by local laws.

Cleaning

For general cleaning, wipe the case, front panel keys,
and lens using a soft cloth slightly dampened with
water or a non-abrasive mild cleaning solution that
does not harm plastics.
W
Do not use CRC Cable Clean
chlorinated solvent or aromatic
hydrocarbons on the test set. Doing so will
damage the test set.

Replacing the Battery

See Figure 4.
To replace the 9 V battery:
W
Warning
Be sure to account for all hardware
removed. Loose or missing hardware could
create a hazard for the end user. Be sure to
replace the battery with a good 9 V alkaline
battery or the test set will not operate
properly.
Disconnect the test set from the line and place on
1
a flat work surface with the battery cover up.
Maintenance
X
Caution
®
or any
X
17